lap joint

英 [læp dʒɔɪnt]

美 [læp dʒɔɪnt]

（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝

计算机化学

英英释义

noun

• joint made by overlapping two ends and joining them together
  Synonym:splice

双语例句

• Test shows that this way can exhibit good result to butt joint and lap joint of TIG welding and accurately abstract welding seam out, to the welding seam of large magnitude dogleg angle shows good tracking effect ( dogleg angle< 68 °) and procession speed< 100 ms.
  实验表明，系统对TIG焊的对接和搭接焊缝有很好地处理效果，对大幅度折线焊缝也能很好的跟踪（折线角>68°），处理速度>100ms。
• Numerical analysis on stress distribution in single lap joint with a metal inlay
  含镶嵌块单搭接接头应力分布的数值分析
• Research and optimization design of a riveted longitudinal lap joint in integral panel structure
  整体壁板结构纵向连接接头的优化设计
• Finite element analysis on reliability design of adhesively bonded single lap joint
  基于有限元方法的单搭接接头可靠性设计
• However, further increasing of RE content would degrade the shear properties of the lap joint.
  而当稀土含量进一步增加时，焊点的强度及塑性均下降。
• By comparing the results of buckling analysis, the effects of material nonlinearity, geometric imperfection and lap joint on stability were studied.
  分析了材料非线性、几何缺陷和筒壁搭接对稳定性能的影响。
• The BEM technique for adhesive-bonded structure proves valid by comparing the stress distribution for double lap joint calculated in this paper with that calculated by finite element method.
  对双搭接接头进行了边界元应力分析，并和有限元结果进行了对比，从而证实本文方法的有效性。
• Taking the form of lap joint as an example, the effect of final assembling deviation affect by the assembly sequence was analyzed by adopting the method of worse condition.
  以搭接接头形式为例，采用最坏情况法分析了装配顺序对最终装配偏差的影响。
• The elasto-plastic finite element method ( FEM) was used to investigate the effect of the elastic modulus of adhesive on the stress and strain distribution in adhesively bonded aluminium single lap joint.
  利用弹塑性有限元法研究胶粘剂的弹性模量对单搭接接头应力应变分布的影响。
• A design conception on probabilistic statistics was introduced into adhesively bonded single lap joint, and finite element method was applied to analyze the factors which have important influences on the mechanical property of adhesive joint. Using 100 samples the failure probability was concluded.
  将概率统计的设计观念引入单搭接粘接接头，通过有限元分析方法分析了对粘接接头力学性能影响较大的因素，并在抽样100次的情况下，分析了单搭接粘接接头失效的概率。